A Reclaimed-Wood Display Shelf for Your Collection
Turn old pallet boards into a cubby shelf sized for action figures and die-cast cars — with warm lighting built in.
1 min read

A collection deserves better than a shoebox. This shelf was built from two reclaimed pallet boards and is sized exactly for 3.75-inch figures and 1:64 die-cast cars.
Planning the grid
Measure your tallest figure and add 2 cm of breathing room — that is your cubby height. I went with a 4 × 4 grid of 10 cm cubbies, which fits 16 figures or a lot more cars.
Prepping reclaimed wood
- Pull every nail and check with a magnet for broken-off bits.
- Scrub with warm soapy water and let it dry for a few days.
- Sand just enough to remove splinters — keep the character.
Assembly
Cut half-lap notches so the dividers slot together like an egg crate. A little wood glue in each joint and the whole grid becomes surprisingly rigid.
Lighting
A battery LED string light, stapled along the top edge of each row, gives a warm museum glow. Choose LEDs, not incandescent bulbs — heat and old plastic do not mix.
Happy making! ✂


