Skip to content
The Tinker ShelfSawdust, felt scraps & vintage toys
← Back to the workshop

Building a Wooden Pull-Along Train From One Pine Board

A weekend build with basic hand tools: three cars, chunky wheels, and a finish that is safe for little hands.

1 min read

Sanded pine train pieces and wooden wheels laid out on a workbench beside a saw and a pencil sketch.

There is something about a wooden train that never goes out of style. This one came out of a single 1×4 pine board, a handful of dowels, and a slow Saturday afternoon.

What you need

  • One 1×4 pine board, about 90 cm long
  • 1 cm hardwood dowel for axles
  • 16 pre-made wooden wheels (or cut your own with a hole saw)
  • A coping saw or jigsaw, a drill, and sandpaper from 80 to 220 grit
  • Food-safe finish — I like a beeswax and mineral oil blend

Cutting the cars

Sketch the engine, a coal tender, and a boxcar directly on the board. Keep the profiles simple: a rectangle with a cab and a chimney is plenty. Rounded corners matter more than detail — little hands find every sharp edge.

Tip: drill the axle holes before you cut the pieces out. The full board is much easier to clamp.

Sanding and finishing

Spend more time sanding than you think you need. Break every edge, then rub in two coats of the wax blend, letting each soak in for about 20 minutes before buffing.

Linking it together

Small screw eyes and S-hooks make a quick coupler. Tie a length of cotton cord to the engine with a big wooden bead on the end, and you have a toy that will roll across the living room for years.

Happy making! ✂